H1
Scalper System is a trend following Strategy based on trend
indicators. This strategy was created by Swing Man for published on
Forex Factory forum.
The
system uses:
HULL
MOVING AVERAGE: 27:3:0
SMA
21, shift 1: High
SMA
21, shift 1: Low
BBands_Stop:
20:2
Depending
if and when the Hull MA crosses the SMA Hi-Lo and BBands_stop
different signals are given which corresponding
to
the trend changing to different degrees of strength.
Indicators:
1.
H1 Scalper OscD1: you will see, three different shades of
green and red (reddish) histogram style bars as well as the
words/letters:
LONG, L2, L1, and SHORT, S2,S1. These are seen in the right bottom
corner of the indicator when various
conditions
are met.
2.
ArenD1 ATR(34) : You will see Magenta
bars = Long Bars with open and close in the third part of the
range, and Orange
bars
=Pin Bars or Dojis.
Conditions
to meet:
Hull
MA trend is either long or short (blue or
orange line colour).
1.
- When CLOSE of the bar crosses either SMA Hi-Lo in the same
direction with the Hull trend, 2 of 4 conditions are met.
Expect
an S1 or L1 on
the indicator, and then on the dashboard an arrow either GREEN
or RED ( ↑
or ↓ thin arrows).
2.
– The two first conditions are met.
When
CLOSE of the bar crosses the BBands_Stop, OR when Hull MA crosses
both SMA Hi-Lo, 3 of the 4 conditions are met.
Expect
an S2 or L2 on
the indicator, and then on the dashboard an arrow either GREEN
or RED (or transparent arrows )
3.
– The two first conditions are met.
When
CLOSE of the bar crosses the BBands_Stop, AND when Hull MA crosses
both SMA Hi-Lo, all 4 conditions are met.
Expect
SHORT or LONG on
the indicator, and then on the dashboard an arrow BLUE
OR MAGENTA ( ↑
or ↓ thick arrows)
An
example of using two Timeframes for scalping.
All
4 conditions have been met. On the H1 the trend is DOWN and 5min is
undergoing a retracement.
Wait
for a SHORT signal on the 5 min Timeframe.
إرسال تعليق